Installation Instructions

Installation Instructions- Goldwing Single Carburetor Conversion

This setup uses only a single throttle control cable. Decelerate control and choke will not be used

  1. Remove intake boots, control cables, fuel lines etc. and remove existing carburetor setup.
    Note: Remove carburetor assembly from left side of engine. Removal of the right front air piston cap will aid in the removal on some models.
  2. Install intake boots onto new manifold making sure that the rubber flanges are in good condition.( Boots can be installed easier by warming in hot water for a few minutes)
  3. Install new manifold with the intake boots back on engine and reinstall the flange bolts. Tighten boot clamps ( 1” stainless 10-32 bolts will be needed because of the larger diameter runners)
  4. Install the carburetor with the throttle control on the right side ( throttle cable bracket side)
  5. Locate positive electrical source ( any wire that goes through ignition switch)
    The fuse box under the top cover is the best location

Connect 2 wires (Positive Terminal) upper screw on right side of fuse box ( verify)
Connect 1 wire (Negative Terminal) lower screw on right side of fuse box (verify)

One positive wire attaches to the electric choke, the other positive wire attaches to the air cut valve.

Attach the ground wire to the Carburetor body

    1. Install fuel line, throttle cable, air filter (optional)
    2. Turn ignition to the on position with the engine in cutoff position and crank the engine a few times to allow fuel into the carburetor.
    3. Re-check all connections i.e. clamps, cables, and fuel lines
    4. Start the engine and allow to idle for a few minutes.
    5. Decelerator cable should be removed to avoid cable jamming. Choke cable can be tie wrapped inside tank cover
    6. Enjoy the Ride!

...................................................................................................................

VW 34 PICT3 Carburetor Preset and Tuning

...................................................................................................................

3 of 4 small holes shown

Turning the carburetor upside down, you will notice 4 small holes (the forth is not exposed)
Only one hole needs to be exposed to set the circuit.

...................................................................................................................

Proper setting of the fuel circuit with 1 hole exposed

Proper adjustment of butterfly with 1 hole exposed

...................................................................................................................

The proper position for the choke cam for adjustment.

Use this adjusting screw to set the throttle plate by turning the adjustment screw until only the last hole is exposed as shown above.

...................................................................................................................

Questions? Comments? Call Us 224-210-6030

Installation Instructions

Installation Instructions-Yamaha Virago Single Carburetor Conversion

  1. Remove existing carburetors and separate them. (If original stock carburetor is used).
  2. Use front carburetor for this conversion
  3. Use existing/original intake boots (rubber fittings) to attach manifold to cylinders.
  4. Install original intake boots onto the manifold.
  5. Install the manifold back on the engine.
  6. (Recommended to install on the left side of the motorcycle).
  7. If original rubber fittings have cracks, is recommended to seal them with silicone gasket maker, to prevent backfire and air leakage.
  8. Tie steel clamps very well.
  9. Attach carburetor using steel shielded rubber fitting included in the package.
  10. Attach throttle cable.
  11. Attach choke cable. (remove choke cable bracket from rear carburetor and re-attach to the front one.
  12. Snap-on 60mm diameter air filter is needed.
  13. Attach snap-on air filter.
  14. Double check clamps and cables.
  15. Turn ignition key on.
  16. Start the engine.
  17. Enjoy the ride.

With stock Hitachi carburetor, needle lifted 0.8mm and main jet is a 140 - 180 , pilot is 42 - 50.

Performance chart

Questions? Comments? Call 224-210-6030